![]() Once you’ve got it working, running a new set on a new piece of material only takes 1 run of the laser. Your way will work as well but you will have to run a couple or few iterations so you can see at what point you want to stop ordering by speed and start ordering by power or making an educated guess as to where it is going to start to char. These can be set for raster (engrave) and/or vector (cut), or skip (off) in the. This results in lost time while the machine is running, but. If there is empty space in the middle, the laser will shut off as necessary, but the lens will continue moving at the same speed. So when I get into the 70/80/90% power levels I adjust the order where speed controls the order vs power - I’ll step through 1000mm/s, 800, 600, 400, 300, 200, 100 at a power level before bumping to the next power levels (80%, 90).īut this works because I did my calibration tools after I had used the laser so I knew where to start. Use raster for engraving and vector for cutting. What is Raster Optimization When raster engraving, the laser sweeps back and forth in horizontal rows, going from the left-most pixel to the right-most. But mine has the lowest power levels run then as I step up the power I deviate a bit in the order I tell the laser to do the boxes - I know from experience that on the 60W that 400mm/s at 50% power is a nice engrave generally on baltic birch. What is raster engraving and vector engraving Raster and vector are two different object types, which require different modes of laser processing. You have it sort of right with the 10p-100s 20p-100s approach. ![]() No point in resending it with those other boxes enabled. ![]() It’s the lower right of my box set (higher power, lower speeds) that are the ones left. By the time I start burning vs engraving the boxes that aren’t burning aren’t really usable either - too much char. I’m imagining running my file starting at 10 power and 100% speed and then moving in a diagonal type pattern until I start burning things.ġ0p-100s, 20p-100s, 10p-90s, 30p-100s, 20p-90s, 10p-80s, etc… Do you then go back and resend the file, but only selecting other boxes that haven’t been run but you suspect won’t cause burning?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |